Basic Rules for Laser Cutting/Engraving

• PPE is not required for operation due to safety interlocks in both laser systems
• You must have previously completed the appropriate hazard communication training for the lab
• A Bechtel Center Peer Mentor must be present during the setup of the laser. Incorrect setup leads to poor cutting and engraving
• Do not tamper with any safety system on the laser or you will be asked to leave. Laser beams move at the speed of light – you cannot dodge them as in films
• If you don’t know what the material is, then don’t cut it. It can poison you, cause a fire, or damage the laser system
• Take note of specific material size requirements for each laser. These will be listed on the information pages linked below
• Ensure exhaust systems are open/connected and on during operation
• You must clean up after you have finished
• Consult with a Peer Mentor if you have any questions, comments, or concerns